25. To feed the wires through the door jamb without them kinking or being pinched, Electric-Life supplies a pair of their billet wire looms with each kit. Typically, these are installed so that the door side is stationary while the loom slides in and out of the A-pillar of the vehicle. On the C10, not only is the inside of the kick panel area inaccessible, which makes installing the collar on the bulkhead fitting impossible, but there’s a panel just inside the jamb that acts to support the door hinge, which prevents the wire loom from sliding into the A-pillar further than an inch or so. This makes it necessary to install the loom in reverse and slightly modified.