Window Glass Rubber Install - Gone With The Wind…

Once it’s in, simply push it up into the corner and tighten up the fasteners evenly until the vent window operates smoothly.

New door glass stop bumpers prevent the sash channel from crashing into the stop bracket when the window is rolled down.

The icing on the cake for the door glass install is to push in the inner and outer window seals. Simply line up the tabs with the holes in the door and push them straight down until they snap into place.

Since we had the door apart, I opted to solve another problem— poorly operating door latch mechanisms. LMC offers these guys up brand spankin’ new, so replacing the old, crusty stock ones was a no brainer.

Next the door panel seal is glued into place…

…before the door panel is installed, followed by the new escutcheons, window crank, and door handle.

And there you have it! Not much to look at as the beauty is really all contained inside the door, but one trip down the road and there’s no doubt about the improvements that have just been made!