|
|
LMC Truck Light Install On Chevrolet C-10 Truck - Bright Lights, Big C10 - Tech
|
|
 Royal Purple Maxfilm worked...  Royal Purple Maxfilm worked wonders freeing frozen bolts, and cleaning dirt and debris from areas that needed a good connection. This is where the stock headlights are grounded.  Having a good ground connection...  Having a good ground connection is as important as having a good positive connection. After cleaning the wires and ground surfaces we used dielectric grease sourced from LMC Truck to ensure long trouble-free service.  Thanks to everything being...  Thanks to everything being clearly labeled it was extremely easy install LMC Truck's relay harness. With this main area all plugged-in, we moved on to connecting the headlight plug for the driver side.  To complete the LMC Truck...  To complete the LMC Truck relay harness install we ran the new wiring alongside of the existing stock wiring on top of the radiator core support. The last steps were to plug in the new headlight plug, connect the new ground wire (same as passenger side), and tuck the now unneeded stock headlight plug away into the fenderwell.  Next in line was to match...  Next in line was to match up the parking lights and DOT side markers with the Euro look. A quick couple of twists on a T-45 Torx driver and the stock lens pulled out with a slight tug to break the old gasket loose.  A Phillips #2 fit snugly into...  A Phillips #2 fit snugly into the LMC Euro parklight assembly to remove the two screws holding it together.  Note the left and right side...  Note the left and right side Euro parklight assemblies are marked specifically for each side, and indicate TOP for the mounting position.  To clean and prepare the area...  To clean and prepare the area for reassembly nothing works as well as Mothers glass cleaner.  With the stock light socket...  With the stock light socket restored to as good as new it was twisted into the Euro parklight backing plate, and then the bulb was tested before the new Euro lens was installed.  To swap out the stock DOT...  To swap out the stock DOT sidemarkers a T-45 Torx was used to remove the lens, and then the light sockets were twisted out to remove.  A hallmark of LMC Truck is...  A hallmark of LMC Truck is to include all of the hardware necessary to install its products. No exceptions. The beautifully chromed Phillips screws come packaged with the Euro sidemarker lights.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The Thinker??? - Haul Monitor
Ryan talks about the friendly badgering that goes on around the shop and overcoming obstacles that seemly pop up out of nowhere during a project....
more
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|