Custom Classic TrucksMagazine Homepage Custom Classic Trucks
Facebook Click here to find out more!

Building A One Off And Roll Pan Install Stock Look

 
 
Building A One Off And Roll Pan Install Stock Look
Building A One Off And Roll Pan Install Stock Look
The first thing I did was to mock up the roll pan in its stock guise. To do this required removing the bumper since the pan was so long and needed to butt up against the bottom of the tailgate. It's still too long so after some careful measurements were made... View Related Article
Building A One Off And Roll Pan Install Rear Building A One Off And Roll Pan Install Plasma Cutter Building A One Off And Roll Pan Install Tailgate Building A One Off And Roll Pan Install Adjusted Jack Stands Building A One Off And Roll Pan Install Trimmed Tube In Place Building A One Off And Roll Pan Install Bottom Of Tailgate Building A One Off And Roll Pan Install Marks
Building A One Off And Roll Pan Install Bolt Holes Building A One Off And Roll Pan Install Socket Cap Bolts Building A One Off And Roll Pan Install Floating Bumper In Building A One Off And Roll Pan Install Roll Pan Building A One Off And Roll Pan Install Stock Look Building A One Off And Roll Pan Install Trimming Excess Metal Building A One Off And Roll Pan Install Iron Panels
Building A One Off And Roll Pan Install Mounting Point Building A One Off And Roll Pan Install Weld Building A One Off And Roll Pan Install Clean Installation Building A One Off And Roll Pan Install Bumper Installed Building A One Off And Roll Pan Install Hiding Back Part Building A One Off And Roll Pan Install Low Profile Roll Pan
Get Adobe Flash player
Custom Classic Trucks