Have you ever noticed how once a project truck hits the road progress slows down-or comes to a complete halt-or maybe even takes a few steps backwards? That's the way it was with this F-1. Purchased as a driver already equipped with a fuel injected small-block Ford, AOD, 8.8 rear, and a Mustang II frontend, the truck just needed a few finishing touches and some TLC to be primo-instead it just got driven for a decade. Despite its rough edges it was fun to drive-but enough is enough. When more and more springs started poking through the seat, the occasional drip of water down the dash when driving in the winter rain turned to a steady stream and the summertime temperature in the cab was roughly the same as under the hood, it was time for action.

The initial steps in our plan were to strip the interior, repair a severely hacked transmission cover, then add some insulation and carpet.

Fortunately, other than the transmission cover, the F-1s floor was solid so it was simply a matter of redoing the damage from a poorly executed floor shifter installation (we're going to switch to a column mounted gear selector). Once that was done we could insulate-for that we chose LizardSkin ceramic insulation. A water-based composition of acrylic binders with air-filled insulating/reflective and sound-absorbing particles, LizardSkin reduces engine and solar heat transfer by 25-30 degrees or more and noise by 10-12 decibels or more. In addition it protects surfaces from moisture and corrosion-we really liked that part because this is an everyday driver that's exposed to the elements so preventing rust is an added bonus.

It's suggested that the ceramic insulation be applied .040 inch (40 mils) thick. Applying .020 inch on the outside of the floor and .020 inch on the inside works well, however in our case spraying the bottom of the cab wasn't an option, so the entire film thickness was applied to the inside surfaces.

When it comes to determining the amount of LizardSkin required is simple enough-divide the number of square feet to be coated by 25 and that's how many gallons will be needed. In our case we would need a little less approximately two gallons.

With the transmission tunnel patched and reinstalled, the insulation shot and cured, the next step was to install the carpet kit from Blue Oval Truck Parts. Pretty much a no-brainer, we laid the carpet out for a trial installation-it fit so well that we pulled it out, shot some spray can adhesive around the edges, in the middle of the floor where our feet will be and in those areas where the carpet had to conform to a reverse curve (like next to the trans tunnel) then dropped it back in place.

Before we wrapped up this portion of our interior update we bolted down a new Lokar Midnite Series Eliminator floor mount throttle pedal and added a matching brake pedal pad. We've still got plenty to do. Next time we'll show how to install new windshield and rear window glass rubber and how to finish off an affordable interior.

SOURCE
Blue Oval Truck Parts
www.blueovaltruckparts.com
Lokar
865-966-2269
www.lokar.com
Eastwood Company
263 Shoemaker Rd
Pottstown
PA  19464
800-345-1178
www.eastwoodcompany.com
Sacramento Vintage Ford
916-853-2244
www.vintageford.com
LizardSkin
www.lizardskin.com
  • «
  • |
  • 1
  • |
  • 2
  • |
  • View Full Article