Chevy C10 Carpret Kit Install

Mario removed the seatbelts and shoulder belts and then set them outside of the cab.

To ensure a clean installation, Mario trimmed the QuiteRide kit away from the edges. This step would be done to conventional padding as well.

Every area in the QuietRide padding that overlapped itself was trimmed to lay flat under the new TrimParts carpeting kit. This step would be done to conventional padding as well.

The next step was to use the scissors to cut out squares for clearance around the seatbelt and seat mounting areas.

With the trimming completed and Mario confident the fit was right, he then glued the QuietRide padding down.

Compressed air was used to blow the area completely clean (a vacuum cleaner could be used instead).

Installing the TrimParts molded carpet kit was begun by spreading it across the cab floor.

The next step was to make sure the carpeting was centered over the transmission tunnel. After the tunnel was pushed by hand into shape, the driver and passenger sides were done (notice weights are being used to hold the carpet into place).

Confident the front half of the carpeting fit right, Mario folded it back and then sprayed glue onto the back of the carpeting and onto the floor (for home use an aerosol glue can be used).