|
|
Chevy C10 Carpet Installation - C-10 Carpet Kit
|
|
 With the initial test fitting...  With the initial test fitting accomplished, the next step was to coat both sides with glue. Then Mario was ready lay the rear of the carpet for the last time.  A single-edge razor was used...  A single-edge razor was used to trim the carpeting away for the bolt-holes.  Notice how vertical slits...  Notice how vertical slits were cut into the edges of the carpeting to make them pliable enough to tuck in. This is step is critical to producing professional results.  These weights were a handy...  These weights were a handy tool as well.  The seat adjusting control...  The seat adjusting control cable (wire) on the Big 10's seat was hanging freely and presented a possible future problem. Mario attached it to the seat springs with a couple of hog rings.  From start to finish it took...  From start to finish it took Mario about two hours to install the TrimParts molded carpeting kit-double that time for a greenhorn.  The finishing touch was a...  The finishing touch was a pair of matching TrimParts floor mats.
|
|
|
|
|
|
|
|
|
|
|
|
|
The Thinker??? - Haul Monitor
Ryan talks about the friendly badgering that goes on around the shop and overcoming obstacles that seemly pop up out of nowhere during a project....
more
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|