|
|
1934 Ford PIckup - Motor And Trans
|
|
 With the chamfered edge toward...  With the chamfered edge toward the transmission, we slid the throwout bearing's adjustment sleeve onto the Tremec's input shaft.  Measuring from the face of...  Measuring from the face of the transmission to the face of the throwout bearing, we arrived at 2.812. According to McLeod's specs, the throwout bearing's position was out of tolerance. We needed a .700-inch spacer to bring it within spec.  Once we had achieved the specified...  Once we had achieved the specified allowable tolerances, the bellhousing was installed for the final time.  Never in a fit of anger beat...  Never in a fit of anger beat on your transmission with a hammer-you might break some expensive parts.  Without allowing the transmission's...  Without allowing the transmission's weight to bear on the clutch disc, we carefully shoved the transmission into place, then immediately screwed the mounting bolts in and torqued them down. Failure to observe this last step can result in a warped clutch disc, and guess what? You will have to start all over again.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The Thinker??? - Haul Monitor
Ryan talks about the friendly badgering that goes on around the shop and overcoming obstacles that seemly pop up out of nowhere during a project....
more
|
|
|
|
|
|
|
|
|
|
|