1971 Chevy C10 - One Piece Window Conversion Kit Install - Room To Vent

Now install the weatherstripping into the door track from the bottom all the way up around the window edge. There's no need to use any adhesive in this portion, as it will hold itself in.

Cut a small portion to go from the corner wedge up to the top of the edge.

Install the cut piece into the door.

With the window track weather-sealed, the door was ready to be installed, so we put it back onto its hinges. Have a friend hold the door as you put the fasteners through the hinges.

Snug up all the bolts and align with the Sharpie line previously drawn on, then tighten the door.

Install the window sash into the door and on the window regulator.

Next, put the new glass into the door and into the sash. Roll the window up to align the sash in the correct place and mark with a Sharpie.

The window is easiest to mark when in the down position, so make sure it doesn't move at all on its way down.

Pull the glass and sash back out of the door and apply the setting tape into the sash, then push the glass in.