1971 Chevy C10 - One Piece Window Conversion Kit Install - Room To Vent

Here's what the sash looks like with the setting tape applied and ready for the glass.

Be sure to line up the marks on the glass with the edges of the sash.

We used some silicone spray to make it easier to install the sash onto the glass. The spray will evaporate so it won't be slippery later on.

We then took a razor blade and gently cut off the extra setting tape to make for a clean installation.

Place the finished window into the door. Make sure to align the front and back into the window tracks. You may need to unbolt the regulator to get it to move enough to slide onto the lower track.

Once the window's installed, it's time to install the felt and outer weatherstrip. These pieces push into place and clip in the door edge.

Then the outer weatherstrip went in place.

We installed the door panel back on by sliding it up into the track, then the four screws along the lower edge.

Here's the lever and clips. You need to push the clip into the handle as shown to install them.