1971 Chevy C10 - One Piece Window Conversion Kit Install - Room To Vent

We cut ours again in the bandsaw, though you can use any proper cutting tool.

The back and front view of the finished product...

...are revealed in these two photos.

With the front door jamb edge, drill a 3/16 hole to attach the lower front edge track. We laid it out in masking tape. The hole needs to be 1/2 inch up from the lower door hinge's upper ledge and 3/4 inch in from the first edge toward the outside of the door.

Another reason to remove the door is to be able to grind down the check link. Mark it out as shown and cut as close to the rivets as possible without grinding through them.

We began with a cutoff wheel to cut away the big portion and finished it off with a small grinding wheel.

To begin assembly, install the corner wedge into the door edge corner with the provided screw. We had our corner wedges powdercoated black to blend in better.

Apply a small amount of weatherstrip adhesive into the front track and install the weatherstripping.

Slide the track into the door and push into the corner wedge at the top. Run the lower screw into the track and through the weatherstripping; it will help hold the weatherstripping in.