|
|
TCI Four Link Suspension - TCI Four-Link Install
|
|
 ...(This dimension can vary...  ...(This dimension can vary from truck to truck. First check to see if the crossmember will fit into place without this step.)  With the framerails opened...  With the framerails opened to allow a snug fit, the crossmember was driven home using the soft-blow hammer.  George used the 12-inch crescent...  George used the 12-inch crescent wrench to vertically align the crossmember's mounting bolt-holes.  He put the crossmember and...  He put the crossmember and stock...  ...rear brace mounting bolts...  ...rear brace mounting bolts in place.  Oops, first align the bolt...  Oops, first align the bolt holes...  ...and then bolt up.  The coilover shock mounting...  The coilover shock mounting points are shown. Note the pickup point for the track rod on the lower shock mount.  Here we see the differential...  Here we see the differential bolted into place.  After everything was bolted...  After everything was bolted into place, George checked that the rearend (differential) was centered.  This is how a properly installed...  This is how a properly installed TCI four-link kit should look. While unnecessary, you could weld it in afterward.
|
Total Cost Involved Engineering
1416 W. Brooks St.
Ontario
CA
91762
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
The Thinker??? - Haul Monitor
Ryan talks about the friendly badgering that goes on around the shop and overcoming obstacles that seemly pop up out of nowhere during a project....
more
|
|
|
|
|
|
|
|
|
|
|